Disassembling your Folletto VK 135 vacuum engine may seem like a daunting task, but with the right guide, it can be a relatively straightforward process. In this step-by-step guide, we will walk you through each stage of the disassembly process to ensure a smooth experience. Let’s get started!

Tools Required

  • Screwdriver (Phillips)
  • Tweezers
  • Cleaning brush
  • Container for small parts

Step 1: Unplug the Vacuum Cleaner

Prior to disassembling the engine, make sure the vacuum cleaner is turned off and unplugged. Safety is essential during any maintenance or repair work.

Step 2: Remove the Dustbag

Locate the dustbag compartment on your Folletto VK 135 vacuum cleaner and open it. Carefully remove the dustbag by pulling it out gently. Dispose of the old dustbag responsibly.

Step 3: Remove the Cover

Using a Phillips screwdriver, remove the screws securing the cover of the vacuum engine. Place the screws in a container to keep them organized and prevent loss. Carefully lift the cover off the vacuum cleaner and set it aside.

Step 4: Access the Engine Compartment

With the cover removed, the engine compartment will be visible. Take some time to familiarize yourself with the components and their locations.

Step 5: Disconnect Electrical Connections

Identify the electrical connections on the engine. Gently disconnect each wire by firmly pulling it away from its connection point. Take note of the specific connections to ensure proper reassembly later.

Step 6: Remove the Motor

Locate the motor assembly within the engine compartment. Carefully lift the motor out of its housing, ensuring not to damage any surrounding components. Place the motor in a safe location.

Step 7: Clean and Inspect Components

Use a cleaning brush or compressed air to remove dust and debris from the motor and other components. Take this opportunity to inspect the parts for any signs of damage or wear that may require replacement.

Step 8: Reassemble the Vacuum Engine

Now that you have cleaned and inspected the components, it’s time to reassemble the vacuum engine. Follow the steps in reverse order, starting with placing the motor back into its housing and reattaching the electrical connections.

Step 9: Replace the Cover and Dustbag

Once the engine is reassembled, carefully place the cover back on top, aligning it with the screw holes. Secure the cover by reinserting and tightening the screws. Finally, insert a new dustbag into its compartment.

Step 10: Test and Enjoy

Plug in your Folletto VK 135 vacuum cleaner and turn it on to ensure the engine is working properly. Enjoy the renewed performance of your vacuum cleaner!

By following these simple steps, you can easily disassemble your Folletto VK 135 vacuum engine for maintenance or repair. Remember to exercise caution and take your time to avoid any damage. Happy cleaning!

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0Vota per primo questo articolo!