Gather the necessary tools
Before you begin disassembling the Folletto VK 131 vacuum cleaner motor, make sure you have the following tools handy:
- Small screwdriver set
- Needle-nose pliers
- Flathead screwdriver
- Soft brush or toothbrush
Ensure safety first
Always unplug your vacuum cleaner from the power source before attempting any disassembly. This will prevent any risk of electric shock or injury during the process. Safety should always be your priority!
Remove the motor cover
Start by locating the motor cover, which is usually situated on the top or side of the vacuum cleaner. Use the appropriate screwdriver to carefully remove the screws holding the cover in place. Set the screws aside in a safe place to avoid losing them.
Disconnect the motor wires
Once the motor cover is removed, you’ll see a small circuit board with wires connected to it. Use the needle-nose pliers to gently disconnect the wires from the circuit board. Take note of the wire colors and their respective positions for reassembly later.
Detach the motor from the housing
With the wires disconnected, you can now proceed to detach the motor from the vacuum cleaner housing. Depending on the model, there may be additional screws holding the motor in place. Use the appropriate screwdriver to remove these screws and carefully lift the motor out of the housing.
Clean the motor components
Once the motor is out of the housing, it’s a good idea to clean the components for optimal performance. Use a soft brush or toothbrush to gently remove any dirt, debris, or dust from the motor and its parts. Ensure your cleaning technique is gentle to avoid damaging any delicate components.
Inspect and replace faulty components
While cleaning, inspect the motor components for any signs of damage or wear. Check the carbon brushes, bearings, and any other moving parts for possible replacements. If you notice any faulty components, it’s recommended to replace them to maintain the motor’s efficiency.
Reassemble the motor
After cleaning and replacing any necessary components, it’s time to reassemble the motor. Carefully place the motor back into the housing, ensuring it is properly aligned. Use the appropriate screws to secure the motor in place. Reconnect the wires to their original positions on the circuit board using the needle-nose pliers.
Replace the motor cover
Finally, it’s time to replace the motor cover. Line up the cover with the vacuum cleaner housing and insert the screws back into their respective holes. Tighten the screws using a screwdriver until the cover is securely attached.
And there you have it! You’ve successfully disassembled and reassembled the motor of your Folletto VK 131 vacuum cleaner. With regular maintenance, your vacuum cleaner should continue to work efficiently.
Remember, if you’re uncertain about any step or encounter difficulties, it’s always best to consult the official Folletto VK 131 vacuum cleaner manual or seek professional assistance.
Happy cleaning!