Are you looking to give your vehicle a sleek and stylish look? One way to achieve this is by darkening your rear lights. Darkened rear lights not only enhance the visual appeal of your car but also give it a unique and sporty touch. In this step-by-step guide, we will walk you through the process of darkening your rear lights. Follow these instructions carefully, and you'll have your vehicle looking fabulous in no time!

What You'll Need

  • A pair of rear light covers
  • Masking tape
  • Sandpaper (medium and fine grit)
  • Plastic adhesion promoter
  • Spray tint or removable vinyl film
  • Isopropyl alcohol
  • Clean cloth
  • Clear coat spray
  • Optional: Hairdryer or heat gun

Step 1: Prepare Your Lights

Start by thoroughly cleaning the rear lights with isopropyl alcohol and a clean cloth. This will ensure that the surface is free of dirt, wax, or any other contaminants that may affect adhesion.

Step 2: Tape off the Surrounding areas

Use masking tape to create a protective border around the lights. This will help protect the surrounding car paint from any accidental overspray or scratches during the tinting process.

Step 3: Sand the Lights

Using medium grit sandpaper, gently sand the surface of the lights. This step will help the adhesion promoter and tint adhere better to the lights. Once done, wipe away any dust with a clean cloth.

Step 4: Apply Adhesion Promoter

Apply a plastic adhesion promoter to the lights according to the manufacturer's instructions. This product enhances the bond between the lights and the tint or vinyl film, ensuring a long-lasting finish.

Step 5: Apply the Tint

If you're using a spray tint, hold the can approximately 6-8 inches away from the lights and apply an even coat. Allow the first coat to dry before applying additional coats if needed. For removable vinyl film, carefully apply it to the lights, smoothing out any bubbles or wrinkles using your fingers or a squeegee.

Step 6: Optional: Heat the Tint

If you're using a spray tint, you can use a hairdryer or heat gun on a low setting to gently heat the tint after it has dried. This step helps the tint bond better with the lights, providing a seamless finish.

Step 7: Apply Clear Coat

To protect the newly tinted lights, apply a clear coat spray. This will ensure the tint or film stays in place and is less prone to scratches or fading caused by UV rays.

Step 8: Let It Cure

Allow the tint or film to cure according to the manufacturer's instructions. This will ensure a durable and long-lasting finish. Avoid washing or exposing the lights to excessive moisture during this curing period.

Step 9: Remove the Tape

Once the tint or film has fully cured, carefully remove the masking tape from the surrounding areas. Be gentle to avoid any accidental damage to the paintwork.

And there you have it! By following these simple steps, you can easily darken your rear lights and give your vehicle a bold new look. Remember to always refer to the manufacturer's instructions for specific details on the products you are using. Enjoy your newly customized ride!

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0Vota per primo questo articolo!