USB debugging is an essential feature for Android users who want to connect their device to a computer or use certain development tools. However, if your phone is locked and you are unable to access the settings, enabling USB debugging can be a challenge. But worry not! In this step-by-step guide, we will walk you through the process of enabling USB debugging on a locked phone.

What is USB Debugging?

USB debugging is a feature found in the Developer Options of Android devices. When enabled, it allows the device to communicate with a computer via a USB connection. This feature is primarily used for app development, debugging, and executing commands on the device using Android Debug Bridge (ADB).

Why Enable USB Debugging on a Locked Phone?

Enabling USB debugging on a locked phone can be useful in various scenarios. It allows you to access the device's data, such as photos, contacts, or messages, when the screen is broken or unresponsive. It also helps in bypassing the lock screen, if you have forgotten your password or pattern. Additionally, USB debugging can be helpful for troubleshooting software issues or performing system updates.

Step 1: Install ADB and Fastboot

The first step is to install the Android Debug Bridge (ADB) and Fastboot on your computer. These tools allow you to communicate and control your Android device via a USB connection.

  • Download the Android SDK Platform Tools package from the official Android Developers website.
  • Extract the downloaded package to a convenient location on your computer.
  • Add the location of the extracted folder to your computer's PATH environment variable.

Step 2: Connect the Locked Phone to Your Computer

Connect your locked phone to the computer using a USB cable. Make sure to use a cable that supports data transfer.

Step 3: Boot the Phone into Recovery Mode

To enable USB debugging on a locked phone, you need to boot it into recovery mode. The exact method can vary depending on the device, so please refer to your phone's instruction manual or visit the manufacturer's website for specific instructions.

Step 4: Open Command Prompt or Terminal

On your computer, open Command Prompt (Windows) or Terminal (Mac or Linux).

Step 5: Execute ADB Commands

In the Command Prompt or Terminal, navigate to the location where you extracted the ADB and Fastboot tools.

Type the following command to check if your device is successfully detected:

adb devices

If your device is listed, you can proceed to the next step.

To enable USB debugging, execute the following command:

adb shell setprop persist.adb.notify 0

Once executed, disconnect your phone from the computer.

Step 6: Repeat Steps 2 and 3

Reconnect your phone to the computer and boot it into recovery mode once again.

Step 7: Execute Another ADB Command

In the Command Prompt or Terminal, enter the following command:

adb shell setprop persist.service.adb.enable 1

Disconnect your phone from the computer once the command is executed successfully.

Step 8: Reboot Your Phone

Finally, reboot your phone normally. USB debugging should now be enabled.

Voila! You have successfully enabled USB debugging on a locked phone. Now you can connect your device to a computer, access its data, or perform various advanced tasks.

Please note that enabling USB debugging on a locked phone can have security implications, and it should only be done when necessary.

We hope this step-by-step guide has been helpful. If you have any questions or encounter any issues, feel free to leave a comment below. Happy debugging!

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0Vota per primo questo articolo!