34 
0 
Is your Hotpoint dryer making strange noises or not tumbling properly? It could be a sign that you need to change the belt. Don't worry, replacing the belt on your Hotpoint dryer is a relatively simple task that you can do yourself. In this step-by-step tutorial, we will guide you through the process.
What you'll need:
- Replacement belt for your Hotpoint dryer
- Screwdriver (Phillips and flathead)
- Pliers
- Putty knife
Step 1: Safety first!
Before starting any repair work on your dryer, make sure to unplug it from the power outlet. This will prevent any accidental injury or damage to the appliance.
Step 2: Accessing the belt
Use a putty knife to gently pry open the top panel of your Hotpoint dryer. There are two clips located between the top panel and the front panel. Insert the putty knife between the clips and push them inward to release the top panel.
Step 3: Removing the front panel
Once the top panel is released, lift it up and lean it against the wall behind the dryer. Now you can remove the two screws located inside the front panel on the upper corners. Use the appropriate screwdriver to unscrew them.
Gently pull the front panel forward and disconnect the wiring harness that connects it to the dryer. Be careful not to damage the wires or connectors.
Step 4: Taking out the old belt
Look inside the dryer cabinet and locate the old belt that needs to be replaced. Use pliers to release the tension on the belt by pushing the idler pulley towards the motor. Slip the belt off the motor and pulley.
Step 5: Installing the new belt
Take the new belt and loop it around the drum of the dryer. Make sure it sits on the groove located towards the back of the drum. Then, guide the belt through the idler pulley and around the motor pulley.
Step 6: Reassembling the dryer
Reattach the front panel to the dryer cabinet by securing it with the screws you removed earlier. Make sure the panel is aligned properly before tightening the screws.
Next, reconnect the wiring harness to the front panel. Ensure that the connectors are securely in place.
Finally, close the top panel and snap it back into position by pushing down until the clips engage. Double-check that the top panel is securely fastened.
Step 7: Testing the dryer
Plug your Hotpoint dryer back into the power outlet and give it a test run. Make sure it's tumbling properly and listen for any unusual noises. If everything seems to be working fine, then congratulations! You have successfully changed the belt on your Hotpoint dryer.
In conclusion, replacing the belt on your Hotpoint dryer is a fairly straightforward process that you can tackle yourself. Just remember to follow these step-by-step instructions, and you'll have your dryer up and running smoothly in no time.