How to insert the thread into the needle

How to Insert the Thread into the Needle One of the most basic skills every sewer should possess is the ability to thread a needle. Whether you are a novice or an experienced sewer, knowing how to properly insert the thread into the needle is essential. However, for many beginners, it can be a frustrating and tedious task. To help you master this technique and avoid unnecessary struggles, we have put together a step-by-step guide on how to insert the thread into the needle. Step 1: Gather your supplies Before you begin threading the needle, make sure you have all the necessary supplies. This includes the needle, the thread, and a pair of sharp scissors to cut the thread. Having a well-lit and comfortable workspace is also essential to ensure accuracy. Step 2: Cut the Thread Take your sharp scissors and cut a piece of thread approximately 12-18 inches long. Be mindful of the project you are working on and adjust the length accordingly. It's better to have slightly more thread than less, as you can always trim off the excess later. Step 3: Straighten the Thread Hold the cut end of the thread between your thumb and forefinger. With your other hand, firmly but gently run the thread through your thumb and forefinger a few times. This process straightens the fibers and makes threading easier, preventing tangles and knots. Step 4: Insert the Thread in the Eye of the Needle Hold the needle with your dominant hand and the thread with your non-dominant hand. Position the cut end of the thread against the eye of the needle. Using a pinch and roll motion, guide the thread through the eye of the needle. It may take a few tries to get it right, but with practice, it will become easier. Step 5: Double Check the Thread After successfully threading the needle, double-check that you have enough thread on both ends. Ideally, you should have an equal length of thread on each side of the needle. If one side is longer than the other, gently pull the thread through the needle until it evens out. Step 6: Tie a Knot To prevent the thread from slipping through the fabric when sewing, it is crucial to tie a small knot at the end of the thread. Hold the ends of the thread together and tie a simple knot close to the cut end. Make sure the knot is secure but not too large, as it may get stuck in the fabric. Step 7: Trim the Excess Thread Using your sharp scissors, carefully trim any excess thread from the knot you just tied. Leave just a small tail, around ¼ - ½ inch, as having too much excess thread can interfere with your sewing. Congratulations! You have successfully inserted the thread into the needle. With practice, this seemingly simple task will become second nature, enabling you to focus on the more creative aspects of sewing. Remember, patience and perseverance are key to mastering any skill, so don't be discouraged if threading the needle proves challenging at first. Keep practicing, and soon enough, you'll be ready to tackle any sewing project with confidence.