A remove-a-submersible-pump-from-the-well” title=”How to remove a submersible pump from the well”>pump is a vital component of the water system in a well. It is used to extract water assemble-a-pressure–switch-on-a-submersible-pump” title=”How to assemble a pressure switch on a submersible pump”>from the well to the surface for various purposes such as irrigation, household use, and industrial use. However, over time, install-a-submersible-pump” title=”How to install a submersible pump”>submersible pumps may experience wear and tear, resulting in reduced efficiency and performance. In such cases, replacing the submersible pump is the best solution. Here’s how to replace the submersible pump of the well.

Step 1: Turn off the power supply

Before you start replacing the submersible pump, the first step is to turn off the power supply to the pump. This will ensure your safety while working on the pump. You can turn off the power supply at the main breaker .

Step 2: Disconnect the pump

The next step is to disconnect the submersible pump from the water system. This involves disconnecting the electrical wire and the water pipe that is connected to the pump. To disconnect the electrical wire, you need to the junction box cover that protects the wires from water damage. Use a screwdriver to artesian-well” title=”How to install a submersible pump in an artesian well”>remove the screws and lift off the cover. Then locate the wires that are connected to the pump and disconnect them from the terminal.

To disconnect the water pipe from the pump, you need to use a pipe wrench or pliers. Unscrew the pipe from the pump and remove it carefully.

Step 3: Remove the Pump from the Well

The next step is to remove the submersible pump from the well. This involves pulling out the pump from the well casing. However, before you do this, you need to attach a rope or cable to the pump so that you can easily pull it out. Attach the rope to the pump’s lifting eye and slowly pull it out of the well casing.

Step 4: Install the new Pump

The final step is to the new submersible pump. To do this, you need to follow the manufacturer’s instructions carefully. Start by attaching the electrical wires and the water pipe to the new pump. Then, carefully lower the pump back into the well casing using the rope or cable.

Once the pump is in position, check the pump’s alignment to ensure that it is properly installed. The new submersible pump is now ready to be tested.

Step 5: Turn on the Power Supply and Test the Pump

After installing the new pump, you must turn on the power supply and test the pump to ensure that it’s functional. Switch on the main breaker switch to restore the power supply to the pump. Once the power is back on, turn on the pump and check if water is flowing through it. Inspect the new pump thoroughly to ensure that it’s working correctly.

In conclusion, replacing a submersible pump is a straightforward process. With the right tools and a little bit of guidance, you can do it yourself. Remember to always follow the manufacturer’s instructions carefully to ensure safety and proper installation. After you have replaced the submersible pump, it’s important to maintain it regularly to keep it working efficiently.

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0Vota per primo questo articolo!