Below are some of the best methods to safely remove iron-on patches from any clothing or fabric.
1. Use a Hairdryer
One of the simplest ways to remove iron-on patches is using a hairdryer. Turn the hairdryer to high heat and point it directly at the patch. Keep the hairdryer in this position for about 45 seconds to a minute until the patch starts to loosen.
Once the patch is warmed up, use your hands to gently peel it off the fabric. If the patch doesn’t come off easily, use a flat plastic or metal scraper to help loosen it.
2. Heat Transfer Remover
If a hairdryer doesn’t work, you can try using a heat transfer remover. Most craft stores offer this type of product, which is designed specifically to remove iron-on patches.
To use a heat transfer remover, apply it directly onto the patch and allow it to soak in for a few minutes. Once the remover has soaked in, use a scraper to gently lift the patch off the fabric. This method is very effective and should not damage the fabric underneath.
3. Ironing
Another method to remove iron-on patches is through ironing. Place the clothing or fabric patch side down on an ironing board. Then, place a piece of cloth over the patch. The cloth can be a rag or a towel, as long as it’s made of a natural material.
Next, heat up the iron on low heat and start ironing over the cloth in circular motions. The heat will slowly transfer onto the patch, making it easier to peel off. Keep the ironing process going for a few minutes and then lift the cloth to check if the patch is loose.
If you see that the patch has started to lift, use the flat edge of a scraper to gently peel it off. Be careful not to scrape or scratch the fabric underneath.
4. Acetone
One of the more unconventional methods of removing iron-on patches is through the use of acetone. Acetone is a chemical solvent that can dissolve the glue holding the patch in place.
To use acetone, dip a cotton ball in the solvent and apply it directly onto the patch. Let the solvent soak in for a few minutes and then try to peel the patch off. If the patch doesn’t come off easily, repeat the process until it eventually lifts off.
However, be cautious when using acetone as it can damage some types of fabric.
In conclusion, removing iron-on patches can be done without damaging your clothes or fabric. By following these methods, you can safely and easily remove patches and start adding new ones to your collection. Remember to always use patience and caution when removing patches to avoid damaging your clothing.