Hanging wallpaper can be a daunting task, especially if it’s your first time. The key is to take your time and follow the steps carefully. In this article, we’ll walk you through the process of hanging wallpaper strips step by step.

1. Measure the walls

Before you start, you need to measure the walls to determine how much wallpaper you’ll need. Start by measuring the height and width of each wall you want to wallpaper. Calculate the total square footage of the wall surface by multiplying the height and width measurements for each wall. Add these totals together to get the total square footage needed for the room.

2. Choose the right wallpaper

When choosing the wallpaper, make sure to select a pattern that fits with the overall style and mood of the room. It’s important to note that the thicker the wallpaper, the easier it is to hang. Thicker wallpaper is also more resistant to tearing and is better at hiding imperfections in the wall surface.

3. Prepare the walls

Before starting to hang wallpaper strips, prepare the walls first. Clean the walls of any dirt or debris using warm water and a mild detergent. If the walls are already painted or have wallpaper on them, sand them lightly to create a rough surface that will allow the wallpaper to adhere properly.

4. Cut the wallpaper

Cut the wallpaper into strips, leaving a little extra length on each end to allow for trimming later. Be sure to match the pattern on each strip to ensure a seamless look. It’s best to cut all the strips at once so you can efficiently hang them without any interruptions.

5. Apply the adhesive

Apply adhesive to the back of the wallpaper strips using a wallpaper brush or roller. Make sure to apply the adhesive evenly and cover the edges well. Fold the strips in on themselves and let them soak up the adhesive for a few minutes.

6. Hang the wallpaper

Starting in a corner of the room, unfold the top section of the wallpaper strip and align it with the ceiling. Smooth out the wallpaper from the center to the sides using a wallpaper brush, working out any air bubbles. Once the top section is in place, slowly unfold the rest of the strip down the wall, being careful to align it with the previous strip.

7. Trim the excess

Use a sharp utility knife to trim the excess wallpaper from the top and bottom edges. Be sure to trim carefully and avoid cutting into the wall.

8. Repeat

Continue hanging strips until you’ve covered the entire wall. Make sure to match the pattern on each strip and avoid overlapping seams. If you do overlap the seams, use a seam roller to smooth them out.

9. Finish up

Once you’ve hung all the wallpaper strips, use a wallpaper smoothing brush or roller to smooth out any remaining air bubbles. Clean up any excess adhesive using a damp sponge or cloth.

Hanging wallpaper can be a fun and rewarding DIY project. By following these steps, you can achieve a professional-looking finish that will enhance the look and feel of the room. Remember to take your time, measure carefully, and choose the right wallpaper for the job. Good luck!

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0
Vota per primo questo articolo!