How to exclude the photocells of the Nice gate

Photocells are a critical component of a Nice gate system as they ensure safety by detecting obstacles in the gate’s path. However, there may be instances where you need to the temporarily, perhaps during maintenance or repair work. In this article, we will discuss step-by-step instructions on how to exclude the photocells of a Nice gate.

Before we proceed, it is crucial to emphasize that the exclusion of photocells should only be done when absolutely necessary and by trained individuals. Disabling the photocells may compromise the safety of the gate and its surroundings. Therefore, it is essential to exercise caution and re-enable the photocells as soon as their exclusion is no longer required.

Here are the steps to exclude the photocells of a Nice gate:

Step 1: Identify the Control Panel
Locate the control panel of your Nice gate system. It is usually installed near the gate’s motor or in a control box.

Step 2: Access the Control Panel
Open the control panel a screwdriver or any appropriate tools. Be careful not to damage any wires or components inside the control panel.

Step 3: Locate the Photocell Connector
Look for the photocell connector within the control panel. It is a small interface where the photocells are connected.

Step 4: Disconnect the Photocell Wires
Gently remove the wires connected to the photocell connector. There are typically two wires for each photocell – one labeled with “+” or “P” for positive and the other labeled with “-” or “N” for negative.

Step 5: Store the Photocell Wires
To prevent any accidental damage or loss, carefully store the photocell wires in a safe place. You may consider labeling them to make reconnection easier in the future.

Step 6: Secure the Control Panel
Once you have excluded the photocells, securely close the control panel using the screwdriver or appropriate tools to avoid any unwanted tampering or exposure to moisture.

Step 7: Test the Gate
After the photocells, it is essential to test the gate to ensure it is functioning correctly without them. Open and close the gate multiple times, monitoring for any unusual behavior or malfunctioning.

Step 8: Monitor the Gate
During the period of photocell exclusion, it is essential to keep a close eye on the gate and its surroundings for added safety. Regularly check for any potential obstacles or changes that could pose a risk.

Step 9: Reconnect the Photocells
Once the necessity to exclude the photocells has passed, it is crucial to reconnect them promptly. Follow the above steps in reverse order, securely reconnecting the photocell wires to their appropriate connectors in the control panel.

Step 10: Test the Photocells
After reconnecting the photocells, perform a test to ensure they are functioning correctly. Test the gate by placing an obstacle in its path, ensuring it stops upon detection.

In conclusion, excluding the photocells of a Nice gate is a task that should only be carried out when necessary and by trained individuals. It is vital to prioritize safety and promptly reconnect the photocells once their exclusion is no longer required. By following the steps outlined in this article, you can perform this task cautiously and ensure the proper functioning of your Nice gate system.