How to connect the pool cleaner to the skimmer

Maintaining a clean and sparkling pool is essential for every pool owner. One crucial tool that helps in this endeavor is the pool . While there are different types of pool cleaners available in the market, most of them are designed to be connected to the . The skimmer, located on the pool wall, helps in filtering out debris and keeping the water clean. In this article, we will discuss the process of connecting the pool cleaner to the skimmer.

Step 1: Gather all the necessary equipment
Before you begin connecting the pool cleaner to the skimmer, make sure you have all the required equipment. This may include a pool cleaner, skimmer plate, hose, and other accessories recommended by the manufacturer.

Step 2: Turn off the pool pump
For your safety, always turn off the pool pump before attempting to connect the pool cleaner. This will prevent any accidents or injuries.

Step 3: Remove the skimmer basket
To properly connect the pool cleaner, you need to remove the skimmer basket. This will allow the cleaner to have direct access to the skimmer. Gently lift the skimmer lid and carefully remove the basket.

Step 4: Attach the skimmer plate
The skimmer plate acts as an intermediary between the skimmer and the pool cleaner. Check the manufacturer’s to identify the correct skimmer plate for your cleaner. Place the skimmer plate on top of the skimmer, ensuring that it fits snugly.

Step 5: Connect the hose to the skimmer plate
Now it’s time to connect the hose to the skimmer plate. Insert one end of the hose into the opening on the skimmer plate. Make sure it is securely fitted to prevent any leakage or loss of suction.

Step 6: Connect the other end of the hose to the pool cleaner
Next, connect the other end of the hose to the pool cleaner. Most pool cleaners have a dedicated connection point where the hose can be attached. Follow the manufacturer’s instructions to ensure the proper connection.

Step 7: Adjust the hose length
If your hose is too long, it may get tangled or cause the pool cleaner to lose its efficiency. Adjust the length of the hose by removing any excess or hose connectors to extend it if needed. The goal is to have the hose reach all areas of the pool without any obstructions.

Step 8: Submerge the pool cleaner
Slowly submerge the pool cleaner into the pool, ensuring that all air bubbles are released from the hose. This will allow the cleaner to sink to the bottom of the pool and start its cleaning cycle.

Step 9: Turn on the pool pump
Once the pool cleaner is properly submerged, you can turn on the pool pump. The pump will create suction, which will enable the cleaner to move around the pool and collect debris. Monitor the cleaner’s performance and adjust any settings as needed.

In conclusion, connecting the pool cleaner to the skimmer is a straightforward process that requires some basic knowledge and equipment. By following the steps outlined in this article, you can ensure that your pool cleaner is properly connected and ready to keep your pool clean and inviting for all to enjoy. Remember to always refer to the manufacturer’s instructions and prioritize safety by turning off the pool pump before starting any maintenance or connection tasks.