Do you own a Garmin 520 cycling computer and notice that its battery isn’t holding a charge like it used to? If so, it may be time to consider changing the battery. In this step-by-step guide, we will walk you through the process of replacing the battery in your Garmin 520, ensuring you can get back to enjoying your rides without any interruptions.

What You Will Need

  • A small Phillips screwdriver
  • A new battery compatible with Garmin 520 (ensure it has the same specifications)
  • A clean, dry workspace

Step 1: Remove the Mount

Start by removing your Garmin 520 from the mount attached to your bike. Gently but firmly, slide the computer out of the mount to disconnect it.

Step 2: Unscrew the Back Casing

Flip the Garmin 520 over and locate the four screws on the back casing. Using a small Phillips screwdriver, carefully unscrew each screw counterclockwise until they are fully removed.

Step 3: Open the Casing

Once the screws are removed, gently lift the back casing of the Garmin 520 from the front part of the device. Be cautious and don’t force it open, as there may be delicate components inside.

Step 4: Remove the Old Battery

Inside the Garmin 520, you will find the old battery. Gently detach the battery from its connector by pulling it away. Take note of how the battery is positioned to ensure the replacement is installed correctly.

Step 5: Install the New Battery

Take the new battery, ensuring it has the same specifications as the old one, and position it in the same orientation as the old battery. Carefully connect the battery to the connector, ensuring it is securely in place.

Step 6: Close the Casing

Place the back casing of the Garmin 520 onto the front part of the device, aligning the screw holes properly. Gently press the two parts together until they fit snugly.

Step 7: Secure the Screws

Using the small Phillips screwdriver, reinsert and tighten the four screws clockwise into the back casing of the Garmin 520. Ensure they are tight but be careful not to overtighten, as this may damage the casing.

Step 8: Reattach to the Mount

Slide the Garmin 520 back into the mount on your bike by aligning the connectors properly and firmly pushing it into place.

All Set and Ready to Ride!

You have successfully changed the battery of your Garmin 520 cycling computer. The new battery should provide you with extended usage time, allowing you to keep track of your rides without any worries. Remember to properly dispose of the old battery in an environmentally friendly manner. Happy cycling!

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0Vota per primo questo articolo!