How to build a seed blower

If you are a keen gardener or farmer, you might be looking for ways to make your work more efficient and productive. One useful tool that can help in this regard is a seed . A seed blower is a device that can disperse seeds evenly over a large area, saving you time and effort. In this article, we will guide you through the process of building your own seed blower, allowing you to customize it according to your needs and budget.

Materials needed:

– PVC pipe (2-inch diameter)
– PVC elbow joint (2-inch diameter)
– PVC tee joint (2-inch diameter)
– PVC cap (2-inch diameter)
– PVC reducer (2-inch to 1-inch diameter)
– Air compressor
– Air compressor hose
– Drill
– Screws
– Screwdriver
– Air regulator
– Seed canister
– Fine mesh screen
– Adhesive

Step 1: Prepare the PVC pipe
Cut the PVC pipe into three sections. The first section should be around 18 inches long, the second section around 6 inches long, and the third section around 12 inches long.

Step 2: Assemble the PVC parts
Attach the PVC elbow joint to one end of the 18-inch pipe section. Then, attach the 6-inch pipe section to the other end of the elbow joint. Next, connect the PVC tee joint to the end of the 6-inch pipe section. Finally, attach the 12-inch pipe section to the open end of the tee joint. Finish off by capping the end of the 12-inch pipe section with the PVC cap.

Step 3: Create the seed canister
Take a small plastic container such as a Tupperware box and cut a hole in the lid to match the diameter of the PVC reducer. Use adhesive to secure the reducer in place on the lid. This will serve as the seed canister, where you will put the seeds.

Step 4: Add the mesh screen
Cut a piece of fine mesh screen slightly bigger than the PVC cap’s diameter. Attach the screen to the inner side of the cap using adhesive. This will prevent the seeds from being blown out with the air.

Step 5: Attach the air compressor
Connect the air compressor hose to the seed blower by drilling a hole in the side of the 18-inch pipe section large enough for the hose to fit snugly. Secure the hose in place using screws and a screwdriver. To control the air pressure, attach an air regulator to the other end of the hose.

Step 6: Testing and adjustments
Fill the seed canister with seeds, cover it with the lid, and connect the compressor to a power source. Adjust the air pressure using the regulator until the seeds are being blown out evenly. Play around with the angle and height of the seed blower to achieve the desired dispersal pattern.

With your homemade seed blower, you can now easily distribute seeds over a large area, speeding up the planting process and ensuring more uniform coverage. It is important to note that this DIY project may require some trial and error to fine-tune the settings for optimal performance. Enjoy the benefits of your homemade seed blower and start reaping the rewards of efficient sowing. Happy gardening or farming!