Are you experiencing a cracked or shattered glass on your Honor 7 smartphone? Don’t worry, you don’t have to invest in a brand new device just yet! With a little patience and the right tools, you can easily replace the glass on your Honor 7 yourself. In this comprehensive guide, we will walk you through the step-by-step process of replacing the glass on your Honor 7, so let’s get started!

Gather the necessary tools

Before you begin the replacement process, make sure you have all the necessary tools readily available. Here’s a list of everything you’ll need:

  • Heat gun or hairdryer
  • Suction cup
  • Plastic pry tool
  • Tweezers
  • Replacement glass
  • Adhesive tape or adhesive glue

Step 1: Remove the back cover

Start by heating the back of your Honor 7 using a heat gun or hairdryer on medium heat. This will help soften the adhesive holding the back cover in place. Once it’s heated, use a plastic pry tool to gently lift the back cover. Be careful not to use excessive force to avoid damaging any internal components.

Step 2: Disconnect the battery

Locate the battery connector on the motherboard and gently disconnect it. This step is crucial to ensure your safety and prevent any short circuits during the glass replacement process.

Step 3: Heat the front glass

Using the heat gun or hairdryer again, apply heat to the front glass of your Honor 7. This will make it easier to remove the shattered glass later on.

Step 4: Remove the broken glass

Once the front glass is heated, use a suction cup to pull up and create a small gap between the glass and the frame of the device. Insert a plastic pry tool into the gap and carefully start separating the glass from the frame. Work your way around the edges of the glass until it is completely separated.

Step 5: Clean the frame

Before installing the new glass, it’s important to clean the frame and remove any remaining adhesive. You can use a mild adhesive remover and a microfiber cloth for this task. Make sure the frame is free from any debris and the surface is smooth.

Step 6: Apply adhesive

If your replacement glass doesn’t already come with adhesive, you’ll need to apply a thin layer of adhesive tape or adhesive glue to the frame. Make sure to align the adhesive properly to match the shape and size of the glass.

Step 7: Install the new glass

Carefully align the replacement glass with the frame and gently press it down. Apply even pressure to ensure proper adhesion. Once the glass is in place, use a clean cloth to remove any fingerprints or smudges.

Step 8: Reconnect the battery and replace the back cover

Now that the glass is successfully replaced, it’s time to reconnect the battery. Carefully connect the battery connector back to the motherboard. Finally, place the back cover on the device and press firmly to secure it in place.

And there you have it! By following these easy steps, you can replace the glass on your Honor 7 smartphone and give it a new lease on life. Remember to proceed with caution and take your time throughout the process to avoid any accidental damage. Good luck!

Quest'articolo è stato scritto a titolo esclusivamente informativo e di divulgazione. Per esso non è possibile garantire che sia esente da errori o inesattezze, per cui l’amministratore di questo Sito non assume alcuna responsabilità come indicato nelle note legali pubblicate in Termini e Condizioni
Quanto è stato utile questo articolo?
0Vota per primo questo articolo!